SCSI Boot or IDE?

It really depends... which drive do you want to boot from?

If the system can do either, then it doesn't matter-- just pick a drive to install to, and go from there.

The server by default boots off of the rigfirst SCSI drive and you cant change this setting. However, linux tries to install GRUB o the new IDE drive and when i restart, the system wont boot as the boot loader is on the wrong drive. You can change the gruib location under graphical install but I am using text due to my 1mb graphics card - its rubbish

This means I cant get in to lnux. A friend reccomended a boot floppy but the installer says tehre are too many modules needed, SCSI, RAID etc... to fit on one.

Can you remove the IDE hard drive while installing? what are you mounting it as when you install?

I can tell you this much-- removing that drive will force it to install to /dev/sda. Otherwise, you could use a LiveCD like Knoppix, and chroot into your installation. From there, you could configure grub yourself however you need it to be done.

I am puting /home on the new drive which I got as our areas are getting too big and installing the system rest of the system on the 2 scsi drives, with /boot and swap partitions on sda1 and / on sda2.

I need the IDE drive in whern I install to configure it for /home but damn anaconda wants to install GRUB to it which is wrong. GRUB must be on sda1.

Could I install it as above and use the rescue CD to reinstall grub on the correct HDD?

Why not just leave the drive out at install time?

Simply install without the IDE drive in, then insert the drive, and initialize it, and edit /etc/fstab to mount the drive as /home, and migrate the user's files over. That's all it should take.

Ok ill think ill just leave it blank and unformatted at install time then do it later as you said. Id rather not take it out as its a server where you have to unlcok the doro, take out the security screws, slide it along the rails etc........ (It takes ages)

Thanks!