Member Avatar for lotusorbit

Is Netgear Wireless Router and Linksys Switch compatible? is there any conflict if the two device connected?

  • 3 Contributors
  • 3 Replies
  • 66 Views
  • 6 Days Discussion Span
  • Latest Post Latest Post by Nauman Badiwale

Dani AI

Generated

asked whether a Netgear wireless router and a Linksys switch will conflict. and are right that there is no inherent incompatibility: routers operate at Layer 3 (IP routing/NAT) while switches operate at Layer 2 (Ethernet switching), so a switch simply extends the router's LAN and does not "fight" with it.

Practical notes to avoid common gotchas: plug the switch into a LAN port on the router (not the router WAN/Internet port) so devices on the switch are on the same network. Ensure only one DHCP server is active (the router usually provides DHCP); if a second router is being used like a switch, disable its DHCP or put it into access-point mode. Managed switches with VLANs can block traffic if not configured correctly, so check VLAN tagging if clients on the switch cannot reach the router. Older hardware might require a crossover cable, but most modern Netgear/Linksys gear supports auto MDI-X and auto-negotiation.

Quick troubleshooting checklist: verify link LEDs on both devices, check that clients receive an IP in the router's DHCP range, ping the router gateway, inspect the router's DHCP lease table, try a different cable or switch port, and reboot devices. If problems persist, check firmware updates and any VLAN/ACL settings on a managed switch.

Recommended Answers

All 3 Replies

Member Avatar for Member #119018

They should work together so long as they all work on the same protocols.

Member Avatar for lotusorbit

Thank you Mr. Dukane.

Member Avatar for Nauman Badiwale

No.They will not conflict.

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.