Netgear WGR614v9 Connection issues with Extender

Question

Cyborggold 0 Newbie Poster

13 Years Ago

Setup is a follows:

DSL Modem ~> Netgear WGR614v9 ~> most computers (wifi) and one Cisco E1000 running DDWRT as an extender for a desktop to avoid buying another wifi card (no money).

The problem I am running into is everything works great on the 196.168.1.x protocol for a few hours to a few days, and then the Netgear switches itself to 10.0.0.1 ip and when I log in to the router I see a message that there was a conflict with the ISP and the address had to be changed.

Is there any way to prevent the Netgear from switching to the 10.0.0.x protocol? I cant get the E1000 to work on the 10.0.0.x protocol either or I would just run with that.

Thanks in advance for any help you can offer!

Edited 13 Years Ago by Cyborggold because: n/a

2 Contributors
2 Replies
161 Views
22 Hours Discussion Span
Latest Post 13 Years Ago Latest Post by Cyborggold

jingda 135 Industrious Poster

13 Years Ago

Try reading this. Maybe this will help you understand more. I have never come across this problem so i could not offer much help

http://www.increa.com/computers/verizon-dsl-hacked-my-network/index.html

Reply to this topic

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.

Cyborggold 0 Newbie Poster · Answer 1 · 2011-08-19T14:20:25+00:00

Try reading this. Maybe this will help you understand more. I have never come across this problem so i could not offer much help
http://www.increa.com/computers/verizon-dsl-hacked-my-network/index.html

Well, it looks like I have a lot of work ahead of me changing a whole bunch of settings, but that should do the trick! Thanks for the article!